Get a Quote
icon-address anqiu , china

welcome to visit us

How to conduct a scientific maintenance of the ultrafine pulverizer

  In industrial production, we will use the ultrafine pulverizer, then you know what problems do you need to pay attention to before or during the use of this machine? How do you take care of? We together look!

  Ultrafine Crusher Operation Procedures 1, check whether there is oil in the lubrication before booting. 2. Remove the metal, sand, stone and other debris in the material to prevent damage to the machine. 3, hand must not reach into the feed port, and do not open the cover in the operation. 4, the screen aperture should be appropriately selected, and the damage should be riveted. 5. It is strictly forbidden to start the load, the machine is running a minute and then feeds, and the appropriate amount of water is marked. 6. Turn a second minute to clear the rest of the machine before the stop. Ultrafine pulverizer adjustment and maintenance 1, mainly damaged parts of the crusher: flat teeth, round tooth, large, small grinding. Flat teeth and round tooth steel processed, dynamic balance, severe grinding, replacement, self-cultivation size, size, per piece of weight, no more than 1 gram, so as not to vibrate, bearing and machine. 2, 0.6-12 mm Various different specifications of sieves. When replacing, the light surface is required. 3, the bearing regularly fills high-speed butter, check once in half a month, and find it in time, it should be replaced or repaired in time. 4. It is strictly forbidden to collide, and the long-term stop should be cleaned inside and outside, properly keep it to prevent rust. 5. All causes of manufacturing are not working properly, users can contact the manufacturer directly, free warranty. Ultrafine pulverizer machine maintenance and storage 1, often inspect the fastening of each component, preventing it from falling off, damaging the machine. 2, each oil injection hole should be refueling, and the bearing portion is cleaned every half year of the lithium-based grease. 3. When there is a shutdown job, the machine should be idled for a period of time, the filler in the package, and then shut down. 4. When the machine's machine is deactivated, the external debris should be removed, and the grease is filled with all rotating parts, stored in the storage of air drying, non-corrosive gas.