Get a Quote
icon-address anqiu , china

welcome to visit us

Crushing mechanism of airflow pulverizer

Crushing mechanism of airflow pulverizer

  Medical airflow pulverizer is mainly suitable for crushing mechanisms to determine its scope of application, high finished product, typical materials include: super tune diamonds, carbon (C) silicon wafer ( Silicon), metal powder, etc., high purity requirements: ceramics (raw materials: non-metallic mineral) pigments, pharmaceutical, biochemistry, et al, low temperature requirements: Medicine, Polyvinyl chloride. Through a part of the air, the normal air changes as a Noble Gases, such as nitrogen, oxygen (Oxidation) carbon gas, allows the machine to be inert gas protection, suitable for flammable and explosive, easy oxidation (Oxidation) And other substance crushing classification. Gasflow pulveral mechanical equipment (composition: drive, transmission, etc.) installation

  (1) should be based on an example, and some drawings, etc., such as this process may be correct. The ultrafine pulverizer utilizes air separation, heavy polishing, and shear, the ultrafine manner is used to achieve a dry material ultrafine pulverized apparatus. It consists of a cylindrical crushed chamber, a polishing wheel, a polishing rail, a fan, a material collection system, and the like. The material enters the cylindrical pulverizing chamber by the feed opening, and is crushed by the polishing wheel that is circumferential movement along the grinding rail, and dissensibly. Broken equipment, you should leave enough space so you can feed and maintain, and so on.

  (2) It is necessary to have sufficient strength (Strength), so it is possible to install. When the ultrafine pulverizer works, the material that needs to be pulverized from the feed homper side of the side of the machine cover, relying on the grinding roller apparatus suspended on the main chamber frame, rotating around the vertical axis, while itself rotates, due to rotation The action of centrifugation, the grinding roller is swinging, tightly pressed into the mill, and the shovel shovel is sent between the mill and the abrasive ring, and the purpose of pulverizing the material is achieved due to rolling rolling of the grinding roller. Lubricating Oil, too much, too little or aging, is mainly due to the main cause of the bearing overheating and damage, so according to the filling quantitative use of lubricant, generally lubricated bearings from 70% to 70% Space, too much or too little is not conducive to bearing lubrication and heat transfer. Increase the use cycle of the bearing. The matching bearing cover is too tight, and the bearing and shaft fit are too tight or too loose.Bearing is overheating. The ultrafine pulverizer utilizes air separation, heavy polishing, and shear, the ultrafine manner is used to achieve a dry material ultrafine pulverized apparatus.

  It consists of a cylindrical crushed chamber, a polishing wheel, a polishing rail, a fan, a material collection system, and the like. The material enters the cylindrical pulverizing chamber by the feed opening, and is crushed by the polishing wheel that is circumferential movement along the grinding rail, and dissensibly. However, this problem, crusher equipment operation, the friction noise and obvious movement. The bearing should be removed. Complete the friction section and then reassemble it as needed.