How to deal with the ultrafine pulverizer

　　The auxiliary machine collector dust collector and filter bag dust collector are integrated, air selective centrifugal shear, no screening net, powder particles can be arbitrarily regulated, after the material is broken, the negative pressure is transported to the drain valve outlet to meet the requirements of the product, It is widely used in chemical, dyes, coatings, pharmaceuticals, food and other industries, ultrafine pulverization, materials for the grade of finished products are carried out in the same closed system, and there is no contamination after dust treatment, which is the ideal equipment for environmentally friendly. There are three types of treatment of ultrafine pulverizing machine: (1) The feed speed is too fast and the load increase is one of the reasons for clogging. Workaround: When using a crusher, during the feed process, you must pay attention to the largermost angle of the meter pointer at any time. If it exceeds the rated current, it represents the motor overload and overload for a long time, which will burn the motor.

　　In this case, the feed door should be reduced or turned off, and the feed mode can be changed by increasing the feeder to control the amount of feed. There is a manual feeder and an automatic feeder, and the user should choose the appropriate feeder based on the actual situation. (2) The discharge tube is blocked or the feed block is too fast, and the crusher is blocked, and it matches the conveying equipment, and the exhaust pipe is weakened or blocked. Solution: After discovering the fault, first remove the non-match conveying device, adjust the amount of feed, so that the equipment is operating normally. The ultrafine pulverizer utilizes air separation, heavy polishing, and shear, the ultrafine manner is used to achieve a dry material ultrafine pulverized apparatus. It consists of a cylindrical crushed chamber, a polishing wheel, a polishing rail, a fan, a material collection system, and the like. The material enters the cylindrical pulverizing chamber by the feed opening, and is crushed by the polishing wheel that is circumferential movement along the grinding rail, and dissensibly. The pulverized material brings out the pulverizer through the negative pressure air flow caused by the fan, into the material collection system, filtered through the filter bag, the air is discharged, the material, the dust is collected, and the pulverization is completed. (3) Hammer, aging, sieve closed, crushing, and crushing materials are too high to block crushers. Solution: The damaged and severe aging hammer should be updated regularly to keep the grinder maintain a good working condition.