How to increase the speed of the airflow pulverizer

Today, we will talk about how to increase the equipment rate of the airflow crusher. After the airflow pulverizer is filtered, the pulverizing cavity is sprayed through the Raval nozzle, and the material is repeatedly collided, friction, shear and pulverized, and pulverized material in the intersection of the multi-shaped high-pressure airflow. Next, the rising airflow is moved to the hierarchical region, and the crude material is separated under the powerful centrifugal force generated by the high-speed rotation, the fine particles that meet the particle size requirements are collected by the grading wheel into the cyclone and the dust collector, and the crude particles drops to the pulverization. The district continues to smash. Ultrafine pulverizer is low, and all of the lifescas is used in high quality wear-resistant materials at home and abroad. It has long service life. A small amount of easy wear parts are made of special hard resistance, small size, light weight, easy to replace the accessories. The ultrafine pulverizer is composed of silo, mechanical pulverizer, air blower, cyclone, vibrating screen, liquid nitrogen tank, etc., the deep-cooling pulverizer system is refined by liquid nitrogen as a cold source, and it is crushing at low temperatures by cooling. After the crushing state, enter the mechanical pulverizing cavity through the impeller high speed rotation, the material and the blade, the tooth disc, the material and the material are enrolled under the integrated effect of collision, shear, friction, etc., to achieve a crushing effect. This paper introduces how to improve the equipment utilization of the gas flow pulverizer.

In addition to some basic aspects, such as the principles, operations and prices of crusher equipment, what else is worth it, need us to explore and understand? This is also a problem that everyone considers when learning this crushing equipment. So today, Xiaobian is paying attention to this important issue to discuss this, mainly discusses how to solve the problem of crusher equipment. Internal speed difference issues allow everyone to use it better and increase our knowledge in this. Why is there a speed difference in the interior of the crusher device? This is mainly because there is a difference in the hammer speed of the hammer and the material in the machine. If the speed difference is reduced, the efficiency of the pulverizer is increased. So, how to reduce the speed difference, then what can you do? The following small series will provide you with specific answers. Action 1: Correct adjustment of the hammer screen clearance is to adjust the hammer screen gap to improve efficiency. However, if you take into account the life of the screen and the hammer and wear, the measures cannot solve the problem for a long time. Action 2: Reasonable use of the anti-hairy thorn to put the pores of the sieve into the inside, so that the friction can be increased, but when the burr of the screen is polished, there is noEffect. Action 3: Increase the suction is to increase the negative pressure for the pulverizer. Although it has a certain effect, it will increase the wear of the sieve and the hammer, and increase the suction consumption.

Welcome to the speed of how to improve the airflow milling equipment.