Safety operation procedure for air current pulverizer

Today I am talking about the safety operation procedures of gas flow mills. After the airflow pulverizer is filtered, the pulverizing cavity is sprayed through the Raval nozzle, and the material is repeatedly collided, friction, shear and pulverized, and pulverized material in the intersection of the multi-shaped high-pressure airflow. Next, the rising airflow is moved to the hierarchical region, and the crude material is separated under the powerful centrifugal force generated by the high-speed rotation, the fine particles that meet the particle size requirements are collected by the grading wheel into the cyclone and the dust collector, and the crude particles drops to the pulverization. The district continues to smash. Ultrafine pulverizer is low, and all of the lifescas is used in high quality wear-resistant materials at home and abroad. It has long service life. A small amount of easy wear parts are made of special hard resistance, small size, light weight, easy to replace the accessories. The ultrafine pulverizer is composed of silo, mechanical pulverizer, air blower, cyclone, vibrating screen, liquid nitrogen tank, etc., the deep-cooling pulverizer system is refined by liquid nitrogen as a cold source, and it is crushing at low temperatures by cooling. After the crushing state, enter the mechanical pulverizing cavity through the impeller high speed rotation, the material and the blade, the tooth disc, the material and the material are enrolled under the integrated effect of collision, shear, friction, etc., to achieve a crushing effect. The safety operation procedure for gas flow mill is introduced.

Welcome to the safety operation procedures for the airflow pulverizer.

There are a lot of knowledge about the airflow pulverizer. Which one will you pay attention to today? For this reason, I have reviewed the content of the previous article and found that it has not introduced its safety operation procedure. Therefore, I want to take this opportunity to introduce this related knowledge so that everyone can master and apply it. Go to practice. 1. Preparation before the airflow pulverizer is started (1) Check if all wiring and electrical components are normal, and whether it is well grounded. (2) Whether the spindle has a card-dead phenomenon, whether there is a debris or debris in the working room, if it is timely, it should be handled or cleaned. After all inspections have no problem, you can start pressing the start button and wait until the machine will run smoothly. 2. Operation and precautions (1) The feed should be uniform, do not excessive, speed should not be too fast, so as not to block the machine or cause the motor to overload, damage the motor. (2) At any time during the operation of the airflow pulverizer, you should pay attention to the operation of the machine. If there is any exception, stop now. (3) General airflow pulverizer does not work for 24 hours in a row, so as not to cause too high of the machine temperature. (4) When the airflow pulverizer is running, it cannot be cleaned.Overhaul, etc. (5) Stopping the feed before the airflow pulverizer is stopped. Wait until the machine stops running, then clean the waste inside and outside the machine. (6) When the pulverizer is parked, it cannot be loaded.