Crusher is constantly upgrading

　　The crusher is constantly upgrading, and the quality of the raw materials is constantly rising, and the low cost of the localized production (Produce) has a low cost, cheap, and domestic crushing equipment has been fully capable of fighting foreign brands. The ultrafine pulverizer is an apparatus for ultrafine pulverization of dry materials using air separation, heavy polishing, and shear. It consists of a cylindrical crushed chamber, a polishing wheel, a polishing rail, a fan, a material collection system, and the like.

　　The market is the opportunity game. In the times of various waste flooded times, the opportunity is wealth. It can be said to be in the case, because China's machinery is in full swing, so the development of machinery and needs China's Development, so the pulverizer has also reached its development of the golden period. With the mechanical replacement of artificial, the demand for machines is increasing, and its market is getting bigger and bigger, the demand for crusher also increases. Our company is a professional crusher manufacturer, has always been high standards, strict requirements, producing a large number of efficiency, high-quality processing equipment (shèbèi). The gas generating pulverizer material enters the cylindrical pulverizing chamber through the feed opening, and is crushed along the grinding rail, and the pulverization is achieved.

　　Welcome customers to come to buy. Protection of the crusher:

　　1. If the rivet head of the impeller (indicating the wheel of the moving leaves) is worn, it can be soldered by pressing the blade and the hub (shape: a bell), allowing the wear rivet head to the original normal. state. Xiao Su Type Grinder is pulverized by the negative pressure air flow caused by the fan, and enter the material collection system. After filtering, the air is discharged, the material, the dust is collected, and the pulverization is completed.

　　2. The case where the rivet bore is easily generated (condition) can be welded with a new electrode that has not been used in the whole root, but is symmetrically symmetrical by the impeller shaft ribbon, and the crack is reinforced. The welding rod stays in this place, and then repairs the relative rivet hole crack with a new electrode.

　　After the welding is soldered, the remaining electrodes are as long as the symmetrical rivet, to ensure the weight of the welding. If there is no cracking at the symmetrical rivet hole, it is also necessary to store the welding rods here to counteract the newly supplemented welding weight at the symmetry rivet hole crack. The crack can be repaired according to the method of such symmetric weight.

　　3. Simple dynamic balance test for impeller, methodIt is also very simple. After branching the impeller, use the hand to make it lightly rotate, and if the balance is not balanced, the lowest point will be stopped. If there is a bias available on the opposite impeller, the weight is increased to balance it, or the weld of the blade of the impeller can be used with a corner mill, so that the fan can be repaired. Good work is working. Note that the welding can not be welded freely in the repair process of the fan, and the soldering can be left on the impeller, so as to avoid the balance of the influence fan impeller, the purpose of repair, resulting in greater losses.