Airflow pulverizer operating procedures Supplementary

　　Shandong AlPa Powder Technology has laminated two years, successfully completed the special ceramic vertical grading wheel of lithium-electric positive electrode materials with a diameter of 600. Can be used with airflow classifiers. Compare the "ceramic horizontal grading wheel", successfully solved a series of problems such as adhesion, not fine, and unsteady. Shandong ALPA-developed lithium-eM positive material special ceramic vertical grading wheel can strictly control the iron content during operation, the grading is accurate, and the finished product is freely adjusted.In the basic knowledge of the airflow pulverizer, in addition to the principle of boot, there are many places that need you pay attention. With the right operating procedures and understanding, it can better operate the airflow pulverizer, and safeguard the safety of the airflow pulverizer and operators.

　　1. Preparation before booting

　　Check the host, accompaniment, pipeline, and valve, etc., whether it is intact, whether it works fine.

　　2. Power on

　　(1) Open the compressor power supply, dust collector pressure valve, the main gas valve, and then open the power switch of the airflow pulverizer, turn on power supply.

　　(2) Start the grading wheel from zero, gradually adjust to the specified speed.

　　(3) Open the fan, the cyclone separator, dust removal, and the power supply, then open the total power supply of the feed bun, set the frequency of the inverter, and then start the addition of pulverization. (4) The particle size of the finished product can be adjusted by the grading wheel frequency and the amount of add.

　　3. Downtime

　　Downture Sequence is: inverter - Takers - Air Pare Valve - Compressor - Section Impeller Motor - Cyclone Distribution Switch - Fan - Total Power Supply - Air compressor.

　　4. Maintenance

　　(1) The motor should be lubricated regularly, but the lubricating oil should not be too much to prevent the bearing temperature too high. (2) Hierarchical impeller, spiral feeder, and smashing nozzles should be appreciated, and the tightness of the transmission belt should be appropriate.

　　(3) After a crushing material is a certain period of time, the attachment powder inside the machine is cleaned to avoid blocking, thereby affecting the pulverization effect.

　　(4) After the filter bag is used for a period of time, or replace it. 5. Precautions

　　(1) When the discharge is running, the outlet of the discharge cannot be extended to avoid accidents.

　　(2) The rotational speed of the impeller cannot exceed the specified, otherwise the temperature is too high, damage the impeller and motor. (3) Safety valve or the like to be verified regularly to ensure safety.

　　In recent years, the attention of green and environmental protection and sustainable development has been mentioned unprecedented, whether it is Ningde era, AlPa powder technology is constantly practicing the concept of sustainable development. In the future, there is still an infinite challenge, but as a large-scale enterprise with social responsibility, ALPA powder technology will continue to adhere to technological innovation, and join hands with partners to achieve economic benefits, environmental benefits and social benefits.